Check Your Bonding Wires

[Gerry Zagorski]

If you leave your boat in the water make sure you check your bonding wires and connections.. This goes for outboard, I/O or Inboards. Your bonding system is important since it protects all the metals that are under the water line from Galvanic Corrosion.

Bonding systems tie all under water metals like though hulls, rudders, drives etc back to your zincs so they get sacrificed before they do.

Was down at the marina today and had 2 wires that went to bond the trim tabs and the rudders that corroded off the connector and had to be re connected.

I've seen all sorts of issues resulting from improper connections.

Had a buddy with twin outboards who kept them titled up and out of the water and thought he was safe.... Turns out the the mounts where the outboards mounted to the transom were in the water and not protected and after one short season they had corroded away and had to replace them.

I've seen IOs get eaten up and inboard props and shafts suffer the same as well as metal through hulls.

Do yourself a favor and check all your bonding system wires or you could be in for a very expensive surprise....

See more here https://www.youtube.com/watch?v=fjtvYr95PLs