![]() |
|
![]() | ![]() | |
![]() | ![]() | |
![]() | ![]() | |
![]() | ||
|
|||||||
| NJFishing.com Fresh Water Fishing Post all your fresh water topics on this board |
![]() |
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
|||
|
|||
|
How often do you guys play with the drag system when bass fishing? Only time I really pay attention is when I go sportsfishing (salt water).
I do pay attention when I use 4 lb line to catch bass but when I use 8 lb - 15 lb lines, I hardly pay attention, except one time when I caught my PB of 6.5 lbs - she was dragging my line all over the place and I had to tighten then let loose my drag system a bit (bait caster reel at that time). Is this usual for most bass angler? |
|
#2
|
||||
|
||||
|
When a big bass wants to run I loosen the drag and let it. Then I'll tighten it up to bring it closer and once I get it boatside I loosen it again in case it takes one last run.
So I do play with it some if its a fish that is putting up a good fight |
|
#3
|
||||
|
||||
|
You can't always rely on your line. If a fish is pulling hard I always loosen the drag because you never know if you have a nick in your line or a weak spot somewhere. Obviously the lighter the line, the more careful you have to be. Also, you never know when a fish will decide to make a hard run and take off.
|
|
#4
|
||||
|
||||
|
If I'm fishing heavy 20-30 lb. line on baitcasters, I'll lock the drag down tight unless I think I'm going to run into a super-big fish. When I fish spinning gear with 4-8 lb. mono, I'll leave the drag loose enough at all times to handle a run from a big fish. The drag should slip a little on the hookset, which is why sharp hooks are a must!
__________________
Now the sun is just starting to climb up over the treetops, And it's gonna be a beautiful day, that's plain to see. But I won't be around at all, so don't even bother to call, Cause on a day like today there's one place I gotta be: GONE FISHIN' Fishing with LardAlmighty on YouTube |
|
#5
|
||||
|
||||
|
.
I got into the habit of setting my drag when I used to do a lot of carp fishing. A 10 or 20 pound carp can snap the mono of an incorrectly set drag with ease. From what I have read in English carp fishing books, the drag is usually set to about one-third (1/3) the breaking strength of the line. I use that as my rule-of-thumb unless there are special circumstances such as fishing elbow-to-elbow with other fishermen (opening day) or there's a tangle of roots and I need to yank the fish away from that. .
__________________
"The fish you release may be a gift to another, as it may have been a gift to you." -Lee Wulf |
|
#6
|
||||
|
||||
|
It also depends what your fishing in regard to structure. If your throwing around lay downs and such you can't really give them an inch. A lot of the time I'm fishing 25lb mono pretty much locked down. On my lighter spinning stuff I'm on the heavier side of line rating unless I am in open water where I can't get taken into structure.
|
![]() |
|
|