Opening eyes on Hooks - NJFishing.com Your Best Online Source for Fishing Information in New Jersey

tropics · #1 02-05-2011, 11:37 AM

Opening the eye of a hook can be a painful task.
Here is the way I do it, Using a vice and a nail set.
Place the nail set in the vice, so that approximatly 3/16"
is sticking in. This will give the gap needed to open the
eye when you tap the nail set, to handle most swivels
see ( pics below )

For those who do not have a vice. Get a piece of 2x4 drill a
3/16" whole in it. Try lining the point of the hook up to the
edge of the board.Close the eye with a vice grips.

Thanks for looking Richie

the1jonc · #2 02-06-2011, 10:15 AM

Thanks for the tip. I was looking for you at the show yesterday.

Jon

Fin Reaper · #3 02-09-2011, 05:07 PM

Nice idea!

Tony Cav · #4 02-10-2011, 05:56 AM

Thanks for the tip.

Have you performed thiis successfully with a forged Gami? I see in the example that you are using SS.

Thanks again

tropics · #5 02-10-2011, 02:13 PM

Quote:

Originally Posted by Tony Cav

Thanks for the tip.

Have you performed thiis successfully with a forged Gami? I see in the example that you are using SS.

Thanks again

I have done a few but more breakage then its worth. even after opening when I went to close they break. The Circle hooks are not SS just chromed.

Thanks for looking guys

dfish28 · #6 02-13-2011, 02:00 PM

ok i have done this one with great success a vise is a very handy tool to have with this one or a good pair of vice grips and a friend with steady hands cause youll need to be holding the other one after a few times itll get real easy.
Heat is the missing element in all of what I have just read posted and if you use a simple propane or mapp gas torch and heat the eye up cherry red it is very easy to manipulate with a pair of vise grips while the hook is locked in the vice just keep the temp up when you are working get the snap, or whatever ring, or such- reheat fast ,and close- dont dip in water to cool!