NJ Fishing Advertise Here at New Jersey's Number 1 Fishing Website!


Message Board


mercury efi failure problem?? please help suggestions needed - NJFishing.com Your Best Online Source for Fishing Information in New Jersey


Message Board Registration       FAQ

Go Back   NJFishing.com Your Best Online Source for Fishing Information in New Jersey > NJFishing.com Boating
FAQ Members List Calendar

NJFishing.com Boating Use this board to discuss anything related to boats and boating in NJ

Reply
 
Thread Tools Display Modes
  #1  
Old 07-06-2014, 05:37 PM
Bass_Appeal's Avatar
Bass_Appeal Bass_Appeal is offline
NJFishing.com Ambassador
 
Join Date: Jun 2011
Posts: 471
Default mercury efi failure problem?? please help suggestions needed

225 merc efi injected , runs great at idle , when throttling up to over 2k rpm it loses power and stalls. Put back in neutral and it fires right up! Go to throttle it wont even get on plane and same thing loses power and stalls
Reply With Quote
  #2  
Old 07-07-2014, 10:02 AM
Capt. Debbie's Avatar
Capt. Debbie Capt. Debbie is offline
NJFishing.com Old Salt
 
Join Date: Mar 2008
Location: Suffern NY / Sandy Hook
Posts: 2,603
Default Re: mercury efi failure problem?? please help suggestions needed

Not sure if same. Likely yes.

In Bombardier- Evinrude/Johnson when have computer problem or overheat problems they rev limit it. Sounds like it'll rip itself to pieces if you throttle past 2500 rpms. It's a "get you home" feature.

May likely be the same thing. If so it's likely not the fuel injection at all. They have computer diagnostics will tell you problem in 60 seconds.

Try Anglers in Sea Bright if you're looking for GREAT Merc work
__________________
Capt. Debs
Tow boat captain/salvor
50 ton USCG Master
NJ Boating College- Lead Instructor
Big time hottie crabber
Reply With Quote
  #3  
Old 07-07-2014, 12:31 PM
Gerry Zagorski's Avatar
Gerry Zagorski Gerry Zagorski is offline
Owner NJFishing.com
 
Join Date: Mar 2008
Location: Edison, NJ
Posts: 11,090
Default Re: mercury efi failure problem?? please help suggestions needed

Is there any audible alarm when this happens?? Is so, like Frank says, it could be going into safe mode... That limits the RPMs when the engine detects an issue like lack of oil or overheating.

If not, sounds like it might be starving for fuel. First thing I would try is running it off a portable tank. If it runs OK then you know you have an issue in your fuel system on the boat.

Once you elimate the fuel system on your boat, I would take it to a mechanic with diagnotic tools to trouble shoot.
__________________

Gerry Zagorski <><

Founder/Owner of NJFishing.com since 1997
Proud Supporter of Heroes on the Water
NJFishing@aol.com
Obsession
28 Carolina Classic
Sandy Hook Area
Reply With Quote
  #4  
Old 07-07-2014, 03:34 PM
wyldbillnj's Avatar
wyldbillnj wyldbillnj is offline
NJFishing.com Ambassador
 
Join Date: Jul 2011
Location: Monmouth County
Posts: 382
Default Re: mercury efi failure problem?? please help suggestions needed

What year is it? Is it a DFI with the high pressure injector on top?
I had a pair of 2002s and the compressor went on top and did same thing basically.
__________________

32ft SeaCraft Master Angler • "Avery Lynn"
WYLD G.F.I. Fishing Team

Sandy Hook Bay Anglers & Instagram
Reply With Quote
  #5  
Old 07-07-2014, 08:51 PM
Bass_Appeal's Avatar
Bass_Appeal Bass_Appeal is offline
NJFishing.com Ambassador
 
Join Date: Jun 2011
Posts: 471
Default Re: mercury efi failure problem?? please help suggestions needed

No alarms , at all , it revs up and shuts down , no warning ! But motor completely shuts down .....turn key and starts right back up. If i put in neutral and rev up i can get it up to 5000 no problem. If i rev up under load it shuts down........
Reply With Quote
  #6  
Old 07-07-2014, 09:13 PM
Katie'sKatch Katie'sKatch is offline
NJFishing.com Regular
 
Join Date: Mar 2008
Location: Philadelphia pa
Posts: 64
Default Re: mercury efi failure problem?? please help suggestions needed

I would just call mercury I have a 2005 optimax I had some problems with they told me everything to check out over the phone. I ordered the part and fixed it myself saved a lot of money. They have good customer service this is my first mercury. It won't hurt to call and see if they can help good luck +1-888-427-5373
__________________
2005 pioneer 197 sportfish
Katie's Katch
Always fishing the Hook
Reply With Quote
  #7  
Old 07-08-2014, 12:52 AM
dfish28's Avatar
dfish28 dfish28 is offline
NJFishing.com Old Salt
 
Join Date: Feb 2010
Location: Port Reading/SRI
Posts: 1,775
Default Re: mercury efi failure problem?? please help suggestions needed

Bassappeal aren't you local to Neptune area?? It's that or Pa I'm not sure, may have a guy with the merc puter if your close...email me for #
__________________
Adam W
20'cc hydra sport-Bad Habit
dfish28@yahoo.com
www.quality1stcompanies.com
Reply With Quote
  #8  
Old 07-08-2014, 10:10 AM
Bass_Appeal's Avatar
Bass_Appeal Bass_Appeal is offline
NJFishing.com Ambassador
 
Join Date: Jun 2011
Posts: 471
Default Re: mercury efi failure problem?? please help suggestions needed

D fish im located in old bridge nj middlesex county , boat is located in matawan nj close to keyport
Reply With Quote
  #9  
Old 07-08-2014, 11:02 AM
Bass_Appeal's Avatar
Bass_Appeal Bass_Appeal is offline
NJFishing.com Ambassador
 
Join Date: Jun 2011
Posts: 471
Default Re: mercury efi failure problem?? please help suggestions needed

Called mercury , and they told me more or less its a fuel issue if no alarms are sounding ....so i have to run through my whole fuel system start to finish and check everything ....to be continued

.....


Dfish if you guy is local and can run a diagnostic or let me borrow the tool please let me know ...the engine is 1996 ...
Reply With Quote
  #10  
Old 07-08-2014, 12:15 PM
PAFireGuy PAFireGuy is offline
NJFishing.com Regular
 
Join Date: May 2013
Posts: 74
Default Re: mercury efi failure problem?? please help suggestions needed

Bass
Seen a similar issue with a faulty fuel tank check valve. There was enough flow to run the engine but not under a load. The valve is normally located on the elbow of the fuel line where it leaves the tank. Good luck, hope this helps.
Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:18 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.