Quote:
Originally Posted by Trevordog
I hear you guys about repairing rather then replacing, but it seems like I have done everything and it still runs like crap. Here is my problem. I can run it for about 30 minutes with no problem. As soon as back down on the throttle for something and then throttle up again, it will run for about a minute and then start to sputter like it is running out of gas, when I squeeze the primer it runs for about a minute and then sputters, pump primer and good for a minute and so on and so on......
I have done a carb kit, changed plugs, thermostat, impeller, fuel pump, oil pressure switch and still no change. Tried running with cap off and on fuel tank with no change.
|
I had a similar problem with an old 6hp evinrude years ago. It would start easily after squeezing the fuel bulb, but sputter out in a short time. I could keep it going with constant squeezing though, even running out on the lake. My problem turned out being leaks in the fuel line between the gas can and the engine. It would run fine as long as I kept the fuel line full by squeezing the bulb, but if I stopped, it would suck air and stall.
Maybe try another fuel line.....borrow one if possible and cross that off the list first before spending the cash for a new engine.
