"Codding Candy"
Cod and Pollack Teaser
Here's a Cod/Pollack teaser that is easy to make and catches fish.
Materials needed...
Krinkle Hair
Flashabou
Mylar tinsel
6/0 Siwash
150-230lb swivel
A thread or monochord
Attach swivel to hook and close eye. (You can do this before or after you tie the fly.)
1. Put hook in vise and wrap first 1/3 with thread
2. Tie in a clump of tinsel and or flashabou on top of hook.
3. Tie in a bunch of krinkle hair on top.
4. Tie in a smaller bunch of darker color on top of that.
5. Rotate vise and tie in a clump of hair equall to what you did on top
6. Wip finish and cement the head.
You can make these in any color. I use green, purple, pink and blue.
Tie them so the hair extends past the bend but not too far as it will foul the hook. I tie them about 2 or 3 inches in length.
A good tip is to cement the head as you go so the fly is durable. I use a deep penetrating head cement during each step and then epoxy the head for a nice finish.
Use these with a teaser rig. I use 100lb test leader material. Tie a 200lb swivel to the 110lb test then tie in a 5 inch kiwi loop a few inches below that.
Cut the leader 24-30 inches below that and tie on a 250 lb snap swivel or perfection loop for the jig or sinker.
Good Luck!
Leif
|
