Bow pulpit

[Islander II]

Looking to replace my fiberglass pulpit on my grady. Anyone know where to buy these. I've done a ton of research and coming up blank. Any suggestions would help. Thanks

[Capt. Debbie]

Repair or replace?

My 25' Grady WA cuddy had a teak inlay surrounded by fiberglass. The rail also went to the end of the pulpit from the cockpit step.

Pulpits replacements are not a common job some would specialize in. You have to break down what you want to do and find trades that fit your needs. Luckily first teak guy may work with a fiberglass guy. Or vice versa.

Good luck!

[Loudsprtfsh1]

What are you looking to replace it with, Or do you want to build a new one?

[Islander II]

I would like to buy one that is fiberglass and fits accordingly to shape of the bow. If I have to build it, I will, but I'd rather just bolt it on.

[Gerry Zagorski]

Is the one you have now bolted on or is it molded into the hull??

If it's a bolt on, these look nice http://www.marineplasticfab.com/bow-pulpits.html

[Islander II]

Is the one you have now bolted on or is it molded into the hull??

If it's a bolt on, these look nice http://www.marineplasticfab.com/bow-pulpits.html
It's a bolt on. I'll give them a shot. Thanks Gerry!

[JayO]

A guy at my marina sent his Grady down to a shop in NC after Sandy that does side work for the builder. You might want to log into a Grady owners forum and ask this same question. I'm sure someone will know the name of the shops that support them. Good luck!

[Kup]

Found this site, may help.

http://www.beachfiber.com/marineproducts.html#pulpits

[Islander II]

Found this site, may help.

http://www.beachfiber.com/marineproducts.html#pulpits
They look nicer than the other ones I've seen. Thank you. I will definitely contact them.