SOLD: PROFESSIONALLY RESTORED - 1985 Mako 236 Inboard Center Console
1985 Mako 236 Inboard Center Console that was professionally restored in 2007. The boat is absolutely turn-key and running in perfect condition. The boat is currently in a marina in Monmouth County, NJ and available for sea trial for a serious buyer. Nothing needs to be done to the boat. Absolutely no expense has been spared in the restoration or upkeep of the vessel. The boat is one of the best riding under 25’ center consoles I have ever operated or rode on. The hull has an incredibly soft ride and does not pound with the weight of the engine in the center of the boat and low.
She cruises at 3200 rpm making 18-20 kts depending on sea conditions and load. My usual load is 3 adults and at this rpm and speed the boat burns 9.2-9.6 gallons per hour.
I am willing to negotiate including the slip for the remainder of the season for the buyer. Too many other things to list. Please let me know if you have any questions.
Asking Price is $24500.
Hull
• 1985 Mako 236 Center Console Hull
• Boat was FULLY restored in 2007 – All work professionally done
• Hull exterior is sprayed with Awl Grip Fighting Lady Yellow. Paint is in perfect shape and shines like new.
• Hull interior is sprayed with Awl Grip white
• Bilge painted with grey bilge coat
• Console painted with white Awl Grip
• Inside of console painted with grey bilge coat.
• Bottom is barrier coated and painted with Interlux Micron ablative paint. Absolutely no paint build-up or chipping.
• Custom recessed Lenco electric trim tabs
• New Stainless engine mounts
• All flotation foam replaced. No wet foam anywhere in the boat.
• Non-skid on forward casting platform
• New latches on all forward lockers
• Custom Starboard anchor locker and console hatches
• New in deck fuel tanks – 45 gallons each side
• New fuel fill lines and fuel vent lines – done in 2007
• All plumbing and electrical done in 2007.
• Custom Leaning post with rocket launcher rod holders, foot rest, and under seat storage and raw water washdown plumbed.
• Custom plumbing/drain system for all forward seating compartments
• Custom Teak deck installed by professional marine woodworker
• Custom Teak covering boards installed by professional marine woodworker
• Custom dash on console with switches
• Stainless pop-up cleats and line chocks
Engine
• 5.7liter 350ci – 260HP Fresh Water Cooled Mercruiser straight inboard
• Velvet Drive 1:1 transmission
• Stainless Morse dual lever control
• Edson steering wheel with power knob
• New exhaust manifolds – March 2015
• New Exhaust elbows – March 2015
• Heat exchanger serviced – March 2015
• New transmission coolder – March 2015
• Engine Coolant flushed and replaced – March 2015
• New raw water circulating pump – March 2014
• New raw water pump impeller – March 2015
• New thermostat – March 2015
• New exhauast manifold gaskets – March 2015
• New exhaust elbow gaskets – March 2015
• LasDrop Dripless Shaft Seal – March 2013
• Acme 1775 Propeller – retuned by Atlantis Propeller – March 2015
• Michigan DJX Spare propeller – retuned by Altantis Propeller – March 2015
• New Edelbrock 1409 marine carburetor with electric choke – March 2014
• New fuel pump – March 2014
• Oil /filters changed every 100 hours
• Oil filter and fuel filter conveniently located on front of engine for ease of maintenance
• Replaced all wet exhaust hose – March 2015
• Installed new Groco sea strainer – March 2014
• Plenty of room in engine compartment for all routine maintenance.
Electrical
• New Interstate group 27 deep cycle battery April 2015
• Interstate croup 27 cranking battery April 2014
• BEP Marine dual charging cluster which isolates starting and house circuits but allows the two to be combined in an emergency situation
• Entire bonding and grounding system replaced with heavy duty marine grade bonding wire.
• Fuse block mounted inside console
• All wiring is marine grade wire with heat shrink on connections.
T-Top
• Custom Tower Power T-Top
• Fiberglass hard top with custom glassed in spreader lights and outrigger mounts
• Custom radome box that allows for proper angle when boat is running on plane
• Custom LED running lights in Hardtop
• Custom Fiberglass electronics box with LED map light
• LED dome light above console on underside of hardtop
• EZ2CY enclosure in excellent condition. Most zippers were replaced last Fall.
• 18’ outriggers included
Electronics
• Furuno 600L Color fishfinder with B744 Bronze thru-hull transducer with high speed fairing block.
• Raymarine 70RLC Pathfinder Combination Radar and Chartplotter display
• Flush mount compass
• All electronics are flush mounted in the console dash.
• Faria engine gauges
• Faria electronic fuel flow guage
Trailer
• Loadrite Dual axel bunk trailer included with the sale. Brakes could use some service but everything else is fine. The boat is stored on the trailer for the winter in my driveway and driven two blocks down the street to the marina.
